I’m finally installing my rebuilt front hubs and have an issue with one of them. Pic attached.
It is a new stub axle assembly but the top and bottom mount points seem to be out of alignment. I’m assuming these should be parallel and this is a supply issue. Does anybody have a view.
Thanks.
Dave.
Front hub install
- Dave Woodward
- T289R Member
- Posts: 917
- Joined: Sun May 06, 2007 10:00 pm
- Location: Cheshire
- Contact:
Front hub install
You do not have the required permissions to view the files attached to this post.
__________________________________
I say, ding dong!
I say, ding dong!
Re: Front hub install
Doesn't look good to me Dave. How does it compare to the other side?
Cheers, Clive.
(If I'm not here I'm in my workshop or on the golf course!)
(If I'm not here I'm in my workshop or on the golf course!)
- Dave Woodward
- T289R Member
- Posts: 917
- Joined: Sun May 06, 2007 10:00 pm
- Location: Cheshire
- Contact:
Re: Front hub install
Hi Clive. Thanks for coming back on this.
I slackened off the top nut in the end and aligned the top and bottom. Has all gone together fine now. I just wasn’t sure as I’d assumed Moss Europe would have built it properly so assumed I was missing something.
Thanks again.
Dave.
I slackened off the top nut in the end and aligned the top and bottom. Has all gone together fine now. I just wasn’t sure as I’d assumed Moss Europe would have built it properly so assumed I was missing something.
Thanks again.
Dave.
__________________________________
I say, ding dong!
I say, ding dong!
- StewbieC
- T289R Committee
- Posts: 1361
- Joined: Mon Oct 13, 2008 12:50 pm
- Location: out in the sticks, Shropshire
Re: Front hub install
Hi Dave,
Glad you've sorted things!
Glad you've sorted things!
________________________________________________
Stu
Hawk 289, 66 Mustang Fastback with a 289 maximum smiles per mile..
Stu
Hawk 289, 66 Mustang Fastback with a 289 maximum smiles per mile..