Clutch slave cylender

Technical Area for all the problems you have in the garage
Post Reply
frats289
Posts: 65
Joined: Fri May 15, 2015 9:26 am

Clutch slave cylender

Post by frats289 »

Damn thing has just failed and I can't remember what it is and where I got it.
Does anybody recognise it - 3/4" bore, drilled for mounting with 3/8" bolts at 21/16" cc

thanks

Frank A
You do not have the required permissions to view the files attached to this post.
User avatar
peterc
T289R Member
T289R Member
Posts: 2041
Joined: Wed Mar 05, 2014 9:05 am
Location: Surrey

Re: Clutch slave cylender

Post by peterc »

Frank, it might help if you remind everyone the type of gear box etc. E.g I think you run a Ford engine and possibly a top loader gearbox. Or is it a Tremec or T5?
Peter C
frats289
Posts: 65
Joined: Fri May 15, 2015 9:26 am

Re: Clutch slave cylender

Post by frats289 »

Absolutely right Peter, Ford 289, Ford toploader, Lakewood steel bell housing.

Frank
User avatar
StewbieC
T289R Committee
T289R Committee
Posts: 1356
Joined: Mon Oct 13, 2008 12:50 pm
Location: out in the sticks, Shropshire

Re: Clutch slave cylender

Post by StewbieC »

Hi Frank,
Not sure if this is close, you could always give them a call?
https://www.mister-auto.co.uk/slave-cyl ... rw/pjd760/
________________________________________________
Stu
Hawk 289, 66 Mustang Fastback with a 289 maximum smiles per mile..
Homewood
T289R Member
T289R Member
Posts: 216
Joined: Thu May 10, 2007 10:35 am

Re: Clutch slave cylender

Post by Homewood »

I suspect any 3/4" seal will fit try paddock spares landrover parts fixed my girling 3/4" master cylinder for under £4.
frats289
Posts: 65
Joined: Fri May 15, 2015 9:26 am

Re: Clutch slave cylender

Post by frats289 »

Thanks Stu, wonderful, I've ordered one and I'm sure I can make it fit.

Thanks again

Frank
Post Reply