Engine and gearbox extracted as of today and I’ve sold the rolling SD1 shell to an enthusiast so this will be going at the weekend
Before I let this go are there any other parts I should consider keeping/using from the donor for my Rover based Hawk 289
Gearbox crossmember ?
Propshaft ?
Radiator ?
Stay Bars for the engine mounts?
Brake servo ?
Clutch master cylinder ?
Wiper motor ?
Speedo Cable ?
Viscous Fan ?
I think the Calipers are 2 pot not 4 so will probably let these go
Any other advice appreciated
Chris
Any other SD1 parts required from donor....?
-
- T289R Member
- Posts: 25
- Joined: Fri Dec 06, 2019 10:03 am
-
- Posts: 378
- Joined: Sat Apr 03, 2010 4:05 pm
Re: Any other SD1 parts required from donor....?
Hi Chris,
Maybe the 'coil', cant think of anything else offhand.
Regards
Maybe the 'coil', cant think of anything else offhand.
Regards
-
- T289R Member
- Posts: 25
- Joined: Fri Dec 06, 2019 10:03 am
Re: Any other SD1 parts required from donor....?
Thanks Allan I’ve kept that
Do you know if I need the stay bars for the engine mounts that the SD1 had for use in the Hawk chassis?
Also are you able to mount a standard SD1 Radiator in the front (space?) or go Gerry’s ally Rad
Do you know if I need the stay bars for the engine mounts that the SD1 had for use in the Hawk chassis?
Also are you able to mount a standard SD1 Radiator in the front (space?) or go Gerry’s ally Rad
Re: Any other SD1 parts required from donor....?
Ignition ballast resistor on inner wing and the wiring harness to go with it.
-
- T289R Member
- Posts: 25
- Joined: Fri Dec 06, 2019 10:03 am
Re: Any other SD1 parts required from donor....?
Got it - thankyou and the wiring