That's nice.
I like how you've recessed the small panel rather than simply screwing it onto the face of the bulkhead.
Paul
BRA289 customized recreation
-
- Posts: 2077
- Joined: Sat Nov 15, 2008 8:20 pm
- Location: Leicestershire, UK
- Contact:
- nikbj68
- T289R Member
- Posts: 1475
- Joined: Thu Jul 17, 2008 3:31 pm
- Location: Anglesey, North Wales.
- Contact:
Re: BRA289 customized recreation
As ever, your attention to detail is astounding!
Hawk 289 FiA...AT LAST!!!
Re: BRA289 customized recreation
Thanks guys. In some areas I "overact" a little bit, in other areas not really
Special customized BRA289
- amulheirn
- T289R Committee
- Posts: 1207
- Joined: Mon May 13, 2013 2:30 pm
- Location: Surrey/Hampshire
- Contact:
Re: BRA289 customized recreation
Can I ask how you did the recessing? It looks very good. Just clever use of a hammer and dolly?
- Roger King
- Posts: 4396
- Joined: Mon Mar 19, 2007 10:29 pm
- Location: St Ives, Cambs
Re: BRA289 customized recreation
Looks like two flat plates, one behind the other. The outer ring of rivets holds the back plate in place, the front plate has a rectangular hole, the other a round.
- amulheirn
- T289R Committee
- Posts: 1207
- Joined: Mon May 13, 2013 2:30 pm
- Location: Surrey/Hampshire
- Contact:
Re: BRA289 customized recreation
Oh - of course. I should have looked more carefully, but am in the office- have to look like I'm doing work things rather than browsing T289R!
Re: BRA289 customized recreation
Looks like two flat plates, one behind the other. The outer ring of rivets holds the back plate in place, the front plate has a rectangular hole, the other a round.
Very correct
Very correct
Special customized BRA289
Re: BRA289 customized recreation
Did a try fit for the passenger seat and had to change the angle of the back, because it was too far away from the rear bulkhead. I tryed to regulate it by putting some additional bracket underneath the front but 120 mm was way to much. So I took the seat cover from the framework, cut off the 2 outer pipes, bent the back and welded it again. Put the cover back on and now it's better.
Special customized BRA289