Damn thing has just failed and I can't remember what it is and where I got it.
Does anybody recognise it - 3/4" bore, drilled for mounting with 3/8" bolts at 21/16" cc
thanks
Frank A
Clutch slave cylender
Clutch slave cylender
You do not have the required permissions to view the files attached to this post.
Re: Clutch slave cylender
Frank, it might help if you remind everyone the type of gear box etc. E.g I think you run a Ford engine and possibly a top loader gearbox. Or is it a Tremec or T5?
Peter C
Peter C
Re: Clutch slave cylender
Absolutely right Peter, Ford 289, Ford toploader, Lakewood steel bell housing.
Frank
Frank
- StewbieC
- T289R Committee
- Posts: 1358
- Joined: Mon Oct 13, 2008 12:50 pm
- Location: out in the sticks, Shropshire
Re: Clutch slave cylender
Hi Frank,
Not sure if this is close, you could always give them a call?
https://www.mister-auto.co.uk/slave-cyl ... rw/pjd760/
Not sure if this is close, you could always give them a call?
https://www.mister-auto.co.uk/slave-cyl ... rw/pjd760/
________________________________________________
Stu
Hawk 289, 66 Mustang Fastback with a 289 maximum smiles per mile..
Stu
Hawk 289, 66 Mustang Fastback with a 289 maximum smiles per mile..
Re: Clutch slave cylender
I suspect any 3/4" seal will fit try paddock spares landrover parts fixed my girling 3/4" master cylinder for under £4.
Re: Clutch slave cylender
Thanks Stu, wonderful, I've ordered one and I'm sure I can make it fit.
Thanks again
Frank
Thanks again
Frank