Help please

Technical Area for all the problems you have in the garage
User avatar
Migge
Posts: 1982
Joined: Tue Feb 20, 2007 5:51 pm

Re: Help please

Post by Migge »

To make it more looking like original, sand down the front edge. Doesn't matter if GRP or aluminium, it was only max. 2 mm thick.
Special customized BRA289
User avatar
Migge
Posts: 1982
Joined: Tue Feb 20, 2007 5:51 pm

Re: Help please

Post by Migge »

I have closed the holes with duck tape from the inside to avoid too much "dirty air"
You do not have the required permissions to view the files attached to this post.
Special customized BRA289
CobStang
Posts: 320
Joined: Sat Dec 10, 2011 3:21 pm

Re: Help please

Post by CobStang »

I have now commissioned a new bonnet to be made with a 45mm high scoop as per original BRA. I have been loaned a bonnet for this task and have been able to contour it to my car. The bonnet will be made over size to allow for trimming, it will be a top skin only, I will make a support tube frame.
I will own the mould, so if anyone needs a replacement or lightweight bonnet that should fit any other Cobra pls get in touch.
Post Reply