Can anyone tell me the length of their shortened IRS driveshafts?
I’ve got the chance to buy a set from an AK and just want to know if they’ve been shortened by the correct amount for a Hawk FIA….
IRS driveshaft length?
- simonjrwinter
- Posts: 1357
- Joined: Sun Jan 03, 2010 8:25 pm
- Location: Upminster, Essex.
IRS driveshaft length?
TR6 (V8) Hawk 289 FIA (V8) Doing my bit for global warming.
Re: IRS driveshaft length?
Inboard disc set up.
Driveshafts = 11.3 inches -- Centre to centre of UJ eyes -
Note - these go with the shortened wishbones provided by Gerry at the same time - these measure 11.8 inches along the tube section (not at yoke eyes).
If not paired, camber is likely to/will be affected.
Cheers, Jack
Driveshafts = 11.3 inches -- Centre to centre of UJ eyes -
Note - these go with the shortened wishbones provided by Gerry at the same time - these measure 11.8 inches along the tube section (not at yoke eyes).
If not paired, camber is likely to/will be affected.
Cheers, Jack
- simonjrwinter
- Posts: 1357
- Joined: Sun Jan 03, 2010 8:25 pm
- Location: Upminster, Essex.
Re: IRS driveshaft length?
So these are too big then…..
You do not have the required permissions to view the files attached to this post.
TR6 (V8) Hawk 289 FIA (V8) Doing my bit for global warming.
Re: IRS driveshaft length?
Yes, I think so.
Cheers, Jack
Cheers, Jack
Re: IRS driveshaft length?
But it depends of the wheels and tire size you will mount too.
Re: IRS driveshaft length?
Karl is running GH wishbones and 9.5" TRIGOS, which are too wide. He had to mill down the center.
https://www.the289register.com/phpBB3/v ... k&start=30
https://www.the289register.com/phpBB3/v ... k&start=30