Page 1 of 1

Static belts

Posted: Tue Jan 14, 2020 12:39 am
by KevinW
Set of Securon static belts - will not pass IVA! The rules changed mid-build for me.
These are unused, sat on shelf since purchase.
WIN_20200114_00_34_07_Pro (2).jpg
I'd prefer someone used these, rather than send to land fill.
Free if you want them - see pic, but a donation for P&P appreciated.
Brackets and spreader plates also available. Might suit older cobra or other classic car.

Surplus to requirements, following winter garage clear out.

Re: Static belts

Posted: Thu Jan 16, 2020 10:09 am
by FIAJack
Kevin,
I'd happily take them off your hands.
Let me know how much you need for P&P and we'll sort it.
Cheers
Jack

Re: Static belts

Posted: Thu Jan 16, 2020 11:22 am
by clive
Why won't they pass IVA?

Re: Static belts

Posted: Thu Jan 16, 2020 11:29 am
by FIAJack
Clive,
Section 31 IVA manual covers. I had this very conversation with the IVA chappy.

" 8. With the seat belt fastened and the seat unoccupied, retractor
mechanisms must take up any excess webbing. (see Note 5)

Note 5: Some types of retracting belt might need help before they retract and harness belts due to their design will not retract however excess webbing
must be secured."

Cheers,
Jack

Re: Static belts

Posted: Thu Jan 16, 2020 1:21 pm
by clive
Yet Note 4 mentions a "Static Seat Belt" :?

Re: Static belts

Posted: Thu Jan 16, 2020 1:39 pm
by FIAJack
Yup - it's a bother!
I can only assume that the reference to static belts relate to harnesses and lap belts where allowed.
Who can tell :-)

Cheers
Jack

Re: Static belts

Posted: Thu Jan 16, 2020 1:57 pm
by KevinW
As Jack says, you need retractor belts or harnesses for IVA.
3 point static belts will not suit.

Jack - I'll pm you - only just seen your message.
Let me know if you want spreader plates etc.

Re: Static belts

Posted: Thu Jan 16, 2020 2:06 pm
by FIAJack
Kevin,
If you want to dispose of spreader plates etc,then once again I'll happily take them.

Look forward to your PM.
Cheers
Jack

Re: Static belts

Posted: Thu Jan 16, 2020 5:17 pm
by KevinW
These are now to being sent to Jack.